Intrusion Switch

This describes the procedure to install and remove the Intrusion Switch.

Removing the Intrusion Switch

• Follow the safety guidelines listed in Safety instructions.
• Follow the procedure listed in Before working inside your system.
• Remove air shroud.
• Remove internal PERC riser.

Follow the below steps to remove the Intrusion Switch:

1. Disconnect the intrusion switch cable connected to the system board.

Note:  Ensure that you note the routing of the cables as you remove them from the system board.

2. Slide the intrusion switch out of the intrusion switch slot.

Installing the intrusion switch

• Follow the safety guidelines listed in Safety instructions.

• Follow the procedure listed in Before working inside your system.

Follow the below steps to install the Intrusion Switch:

1. Align the intrusion switch with the intrusion switch slot.

2. Slide the intrusion switch until it is firmly seated in the intrusion switch slot.

3. Connect the intrusion switch cable to the connector on the system board.

After installing the Intrusion Switch ensure the following:

1. Install internal PERC riser.

2. Follow the procedure listed in After working inside your system.